American Timber and Steel Corp

We designed our American Timber Rail as a cost effective solution for jobs that do not need the strength of our Steel-Backed Timber Guardrail yet it looks great and offers protection around areas like parking lots, pathways and in parks. This easy to assemble guide rail system has 6 foot on center post...

Mortised Post and Rail Systems and Notched Post and Rail Systems are two of American Timber and Steel's biggest customized specialties for uses in parking lots, along driveways, parks and condominium complexes in nearly any design imagined. The Mortised System has the rail going through the center...

Our Steel-Backed Timber and Steel-Backed Log Rail systems are not only beautiful but they have been designed for rugged highway use, crash tested and they meet Federal Highway Administration (FHWA) approval. The Square Steel-Backed Timber also has a TL-2 end terminal system available for another safety...

Made to appear rustic, our 5 Star Split Rail Fencing is the simplest to install. Just set the posts at approximately 10' 4" spacing and the tapered ends on the rails makes it easy to slip the rails into place. Both 2-rail and 3-rail versions are available and the rails are 11' so the tapered...

Our Round American Timber Rail was designed for an even more rustic look than the Square American Timber Rail for jobs that do not need the full strength of our Round Steel-Backed Timber Guardrail yet looks great and offers the protection needed.The dome top on our 7 inch round posts offer an attractive...

Our Texas grown Southern Yellow Pine on our rounder system turns the best looking, clean and uniform round wood bollards anywhere. Customized with decorative tops or drilled holes to allow rope or cable to pass through are common choices. Then we treat with CA-C for environmentally friendly protection...

Square Wood Bollards are another great option to line parking lots, bike paths, buildings or anywhere you want to prevent vehicles for pedestrian safety. If you need a barrier to discourage pedestrians from crossing as well, then add rope and chain strung between each post. Our standard square bollards...

Our agricultural board-on-board fencing, also known as "Kentucky Board Fence" is cut for strength and longevity at 6 inches wide, 1-1/8 inch thick and in 16 foot lengths designed for 8 foot post spacing. We stock them in Southern Yellow Pine or Yellow Poplar. Oak boards are available on a special...

The Snake Rail Fencing zigzags each section and the rail ends overlap recreating the look of early forms of fencing as seen in American historical photographs and paintings. The eleven foot long rails are the same as our regular split rail with the ends taper cut, except that we also offer the rails...

5 Star Round Rail Fencing is available in 2-rail or 3-rail versions using our 4 inch diameter Turned Southern Yellow Pine Posts offering a beautiful, uniform, finished look. The tops of our 6 foot or 7 foot posts are chamfered and the 8 foot rails are doweled and chamfered at the ends. Our pre-assembled,...

As one of the leading manufacturers of round fence posts in North America, our Nacogdoches, Texas mill was one of the first mills in the southern United States to install a system to produce turned posts rather than peeled posts. They are straighter, cleaner and have less bark or unsightly blemishes...

For jobs where a flat surface on a round post is needed to fasten boards, wire or cable, our Round Faced Fence Posts are the perfect solution. We take our quality Round Fence Posts and saw one side flat or "faced" the entire length of the post producing a 3 ½ inch or 4 inch wide nailing surface...

As a leading manufacturer and supplier of materials for nearly 100 either rehabilitated or new covered bridges across America, we are proud to provide a small part in restoring these beautiful historical bridges. American Timber and Steel is uniquely qualified from our extensive work over the years...

Create the ultimate entrance with a Ranch Entrance Timber Kit using our No Taper Poles and adding a custom designed Entrance Sign made from wood or steel. With many options to choose from, our basic Heavy Duty Kit sits the cross pole in a saddle cut on both upright poles with long, heavy duty structural...

Powder coating over the same heavy duty, 12 gauge galvanized rails and components used in highway construction will add years of service life and assist in protection any where needed. Designed to withstand crashes with a pickup truck at 55 MPH may be more than required but will save you money over other...

Some of our more scenic projects that American Timber and Steel has supplied timbers have been bridges for Golf Courses and Rails-to-Trails Bikeways. Project engineers and architects specify our quality timbers not only for their high strength and great looks but also because they are treated to last...

In addition to our wood products, American Timber and Steel carries a full line of steel guardrail and all the hardware and fasteners needed to complete guardrail system installations. We handle 10 Ga. and 12 Ga. Galvanized, as well as, weathering Corten Steel Guardrail and end treatment terminals. All...

Bridge Decking Our ability to supply an extensive array of unique sizes and strength requirements from large timbers to deck boards for Bridges and Bridge Decks has made us known as "The Timber Specialists." American Timber and Steel specializes in both new construction and bridge rehabilitation...

Timber Lagging The versatility of Southern Yellow Pine makes it ideal for many applications of Timber Lagging in highway, industrial and commercial applications being the strongest domestic softwood although the reliable Douglas Fir timber or the old standby Mixed Oak timbers are also available. American...

Our "No Taper Poles" are great for projects that require a more finished look or when a uniform, straight from top to bottom pole is needed. These poles are made to order, turned from Southern Yellow Pine for strength and are great for interior use or treated for exterior use. Often used for...